How long does it take for the
acceptable condensation to clear?
• Clearing time can take as long as 48
hours under dry weather conditions.
How much condensation is
unacceptable?
• A water puddle inside the lamp.
Streaks, drip marks or large droplets
present on the interior of the lens.
What should I do if unacceptable
condensation is present?
• Have your vehicle checked as soon as
possible.
Why do my headlamps turn off
when I have them switched on
when I switch my vehicle off?
• The battery saver turns the headlamps
off after a short period of time after you
switch your vehicle off.
AUTOLAMPS
WHAT ARE AUTOLAMPS
WARNING: The system does not
relieve you of your responsibility to drive
with due care and attention. You may
need to override the system if it does not
turn the headlamps on in low visibility
conditions, for example daytime fog.
Autolamps turn the headlamps on in low
light situations or when the windshield
wipers operate.
AUTOLAMP SETTINGS
Autolamp Exit Delay
You can adjust the amount of time the
autolamps remain on after you switch off
your vehicle. Use the touchscreen to
choose a delay setting.
1. From the settings menu, press Vehicle.
See Center Display (page 457).
2. Press Lighting.
3. Press Autolamp Delay.
4. Select a setting.
Note: If the setting is off, the external
lamps switch off immediately when you
shut down your vehicle.
Note: You can pull the turn signal toward
you to manually switch off the autolamp
exit delay.
EXTERIOR LAMPS
USING THE TURN SIGNAL LAMPS
- EXCLUDING: POLICE
Push the lever up or down to
switch the turn signal lamps on.
Set the lever to the middle position to
switch the turn signal lamps off.
108
Explorer (CTW) Canada/Mexico/United States of America, enUSA, Edition date: 202401, DOM
Exterior Lighting
To Next Page
Loading...
Need help?
General
