WARNING: The system may not
operate properly if your vehicle has a
windshield not approved by us. Do not
carry out windshield repairs in the area
around the sensor.
WARNING: System performance
could be reduced in situations where the
vehicle camera has limited detection
capability. These situations include but
are not limited to direct or low sunlight,
vehicles at night without tail lights,
unconventional vehicle types,
pedestrians or cyclists with complex
backgrounds, running pedestrians or fast
moving cyclists, partly obscured
pedestrians or cyclists, pedestrians or
cyclists that the system cannot
distinguish from a group. Failure to take
care may result in the loss of control of
your vehicle, personal injury or death.
WARNING: The Pre-Collision Assist
system with brake support cannot help
prevent all collisions. Do not rely on this
system to replace your judgment and the
need to maintain correct distance and
speed.
WARNING: Take additional care if
your vehicle is heavily loaded or you are
towing a trailer. These conditions could
result in reduced performance of this
system. Failure to follow this instruction
could result in the loss of control of your
vehicle, personal injury or death.
Note: The system does not detect animals.
PRE-COLLISION ASSIST
LIMITATIONS
Pre-collision assist depends on the
detection ability of its camera and sensors.
Any obstructions or damage to these areas
can limit detection or prevent the system
from functioning. See Locating the
Pre-Collision Assist Sensors (page 309).
The system is active at 3 mph (5 km/h)
and above.
Note: The pre-collision assist system
automatically disables when you select
four-wheel drive low or manually disable
AdvanceTrac™.
Note: Brake support and automatic
emergency braking are active up to the
maximum speed of your vehicle.
Pedestrian Detection Limitations
Pedestrian detection is active at speeds
up to 50 mph (80 km/h).
Pedestrian detection operates optimally
when detected hazards are clearly
identifiable. The system can have reduced
performance in situations where
pedestrians are running, partly obscured,
have a complex background, or when the
system cannot distinguish them from a
group.
Cyclist Detection Limitations
Cyclist detection is active at speeds up to
50 mph (80 km/h).
Cyclist detection functions optimally when
detected hazards are clearly identifiable.
The system can have reduced performance
in situations where cyclists are
fast-moving, partly obscured, have a
complex background, or where the system
cannot distinguish them from a group.
307
Explorer (CTW) Canada/Mexico/United States of America, enUSA, Edition date: 202401, DOM
Pre-Collision Assist
To Next Page
Loading...
Need help?
General
