10
Intended purpose
Environmental
conditions
Obligations of the
operator
The device is to be used exclusively for its intended purpose.
The device is intended for the welding process described on the rating plate
only.
Any use above and beyond this purpose is deemed improper. The manufac-
turer shall not be liable for any damage resulting from such improper use.
Utilisation in accordance with the "intended purpose" also comprises
- reading carefully and following all operating instructions to the letter
- studying and obeying all safety and danger notices carefully
- performing all stipulated inspection and servicing work.
Never use the device for the following purposes:
- Thawing out pipes
- Charging batteries/accumulators
- Starting engines
The device is designed for use in industry and the workshop. The manufactur-
er accepts no responsibility for any damage caused through use in a domestic
setting.
The manufacturer likewise accepts no liability for unexpected or incorrect re-
sults.
Operation or storage of the device outside the stipulated area will be deemed
as "not in accordance with the intended purpose". The manufacturer shall not
be liable for any damage resulting from such improper use.
Ambient temperature:
- during operation: -10 °C to + 40 °C (14 °F to 104 °F)
- during transport and storage: -25 °C to +55 °C (-13 °F to 131 °F)
Relative humidity:
- up to 50 % at 40 °C (104 °F)
- up to 90 % at 20 °C (68 °F)
Ambient air: free from dust, acids, corrosive gases and substances, etc.
For use at altitudes above sea level: up to 2000 m (6500 ft)
The operator undertakes only to allow persons to work with the device who:
- are familiar with the fundamental instructions regarding safety and acci-
dent prevention, and have been instructed how to use the device
- have read and understood these operating instructions, especially the
section “safety rules”, and have confirmed as much with their signatures
- are trained to produce the required results.
Checks must be carried out at regular intervals to ensure that operators are
working in a safety-conscious manner.
To Next Page
Loading...
Need help?
General
