Fronius CMT 4000 Advanced Operating Instructions & Spare Parts

120
Job mode
General Job mode enhances the quality of welding engineering fabrication, both in manual and au-
tomated welding.
Up to 100 common jobs (operating points) can be reproduced in job mode, avoiding the
need to document parameters by hand.
Prerequisites Job mode is only available on power sources with the following control panels:
- Comfort control panel
- US control panel
- TIME 5000 Digital control panel
- CMT control panel
Restrictions Job mode is not available with the TR 2100 TIME remote control and the VR 4000-30 TIME
wire-feed unit. Once the remote control or wire-feed unit is connected, the MIG/MAG pulse
synergic welding process is automatically selected. No other process can be selected on
the power source.
Job mode dis-
plays on the left-
hand digital dis-
play
The following job mode displays are used on the left-hand digital display:
- - - ..... No job in this program location (only when you try to retrieve a job from this loca-
tion, otherwise nPG)
nPG ....No job in this program location
PrG .... There is a job in this program location
Pro ..... Job is being created / copied in this program location
dEL .... Job is being deleted from this program location
Selecting job
mode as the proc-
ess
Press the Process button to select Job mode as the process:
The following activities have to be carried out in Job mode:
- Retrieve a job
- Copy/overwrite a job
The display shows the last job to be used.
Creating a job
The device comes with no jobs pre-programmed. To create a job, proceed as follows:
Set the desired welding parameters that you want to store as a "Job".
1
NOTE! Jobs are not created in the Job mode process. Jobs can be created in the
MIG/MAG pulse synergic welding, MIG/MAG standard synergic welding, MIG/
MAG standard manual welding, TIG welding and MMA welding processes.
1

Fronius CMT 4000 Advanced Specifications

General

Brand	Fronius
Model	CMT 4000 Advanced
Category	AC Power Distribution
Language	English