130
Parameters that
can be corrected
at a later time
Factory setting OFF
t-E
time - End current - Final current duration
Unit s
Setting range OFF or 0.1 - 9.9
Factory setting OFF
SPt
Spot welding time
Unit s
Setting range 0.1 - 5.0
Factory setting 1.0
F
Frequency - for SynchroPulse option
Unit Hz
Setting range OFF or 0.5 - 5
Factory setting OFF
dFd
delta Feeder - Welding power offset for the SynchroPulse option (defined by the wire feed
speed)
Unit m/min ipm
Setting range 0.0 - 2.0 0.0 - 78.74
Factory setting 2,0 78.74
AL.2
Arc length correction 2 (for the upper operating point of the pulsed welding power with the
SynchroPulse option)
Unit % (of welding voltage)
Setting range ± 30
Factory setting 0
NOTE! The arc length correction for the lower operating point is made using pa-
rameter AL.1.
tri
Trigger - subsequent correction of the mode: 2-step, 4-step, special 2-step, special 4-
step, spot welding
Unit -
Setting range 2-step, 4-step, special 4-
step, spot welding
Factory setting 2-step
NOTE! During welding, the welding power (defined by the wire feed speed) or arc
length can only be corrected as follows:
- via the control panel (Comfort, US, TIME 5000 Digital, CMT)
- via the JobMaster welding torch
- via the RCU 4000 remote control
- via Win RCU (JobExplorer software)
- within the defined boundaries (listed below for the parameters PcH, PcL and
AL.c)
To Next Page
Loading...
Need help?
General
