Fujitsu ErgoPro e Series User Manual

PC Specialist's Handbook ErgoPro e-, x- and s- Series
First Edition, Release 4 - June 1998 Page 37
The error code beep sequences are:
Beep code Indicates
••••••••
Error reading diskette
••••••••-
Cannot read diskette (or no diskette in the drive)
••••••
Cannot find the BIOS file
••••-••••
FLASH RAM failed
••••-••-
FLASH RAM erase failed
••••--••
FLASH RAM programming failure
••••---
Bad file
••-••••••
FLASH Boot-block erase failed (BIOS Reload jumper may not be mounted)
Admin-Security menu
The Admin-Security menu appears as shown below and is followed by an explanation of the parameters.
System password
Set a System password when you want to prevent users from altering parameters in the Admin menu and to
establish administrator rights. When setting, changing or removing a system password, follow the same
guidelines and instructions that were given for the User password in the section User-Security menu earlier in
this chapter.
As an alternative to setting a System password, you can also control access to the Admin menus by setting the
System Lock jumper on the system board. For more information and instructions on setting the lock.
User password override
This parameter gives the system administrator the right to remove the User password, if needed; this feature is
useful if, for example, the administrator resides over many users in a controlled environment in which access to
the users' computers is necessary.
The User password override parameter works in the following manner:
1.
The administrator sets User password override to Enabled when a User password is not defined.
2.
The user sets a User password on the system.
3.
The administrator is able to enter the system by overriding the User password.
4.
The user needs to set another User password.
Clear user password
This parameter actually performs the clearing of the User password. If the User password override parameter is
Enabled, the User password is removed from the protected configuration area of the system's memory when this
parameter is Enabled. This parameter has no effect if the User password override parameter is not Enabled.
Minimum password length

Fujitsu ErgoPro e Series Specifications

General

Brand	Fujitsu
Model	ErgoPro e Series
Category	Desktop
Language	English