PC Specialist's Handbook ErgoPro e-, x- and s- Series
First Edition, Release 4 - June 1998 Page 47
Utilities
Video - ErgoGrafix
Install.exe
Install.exe program is used to configure the ErgoGRAFIX PCI video adapter with the monitor in use. All the driver
installations are also done with the install program.
ICL Desktop
ICL Desktop is a Windows application for the ErgoGRAFIX PCI video adapters, and it can be used to set the
resolution and number of colours for Windows environment. Before ICL Desktop can be used, Install.exe must
be used to set the correct monitor type.
Flash.exe
Flash.exe can be used to update the system BIOS through the network or from the floppy drive. The version of
the FLASH.EXE must be 2.35 or later.
PowerMASTER
Power master is available for following operating systems: DOS/Windows and Windows '95
Power master II ver 2.30
This version of Power master is used in ErgoPro e-series, and can not be used in the x- and s-series. The main
reason for this is that this version of Power master does not have support for instant on-functions
Power master III ver 3.1
This version of POWER master is used in ErgoPro x-, x(s)- and s-series, and can not be used in the e-series.
The main reason for this is that e-series does not have support for instant on-functions which are needed with
Power master III.
PMSUSP.SYS (Version 4.00)
Driver makes a copy of the interrupt vectors (part of the instant on function) and must be the first driver loaded in
the config.sys file.
Device = PMSUSP.SYS
PMSUSPE.EXE
This is the actual Suspend/Resume software module (uses the interrupt vector copied by PMSUSP.SYS).
Device = PMSUSP.EXE
APM.SYS (Version 2.0 needed)
APM.SYS is the interface between the operating system (DOS or Windows) and BIOS/Hardware. APM.SYS must
be installed if power management functions are to be used with DOS or Windows. To install it, add the following
instruction in your Config.sys file:
Device = APM.SYS
POWER.EXE
Power.exe is the interface between DOS and APM.SYS. It must be installed if power management functions are
to be used with DOS. If Windows is in use, power.exe is not required. Instead of using power.exe, the computer
type in the Windows setup must be set to MS-DOS System with APM.
To install it, add the following line in your Config.sys file:
Device = Power.EXE
To Next Page
Loading...
Need help?
General