To Next Page

To Previous Page

6-10 ApexPro™ 2001989-351A

Replaceable parts

DC passing attenuators

DC-passing attenuators are used to balance antenna runs.

150A

Notch filters

Notch filters are sealed filters tuned to filter specific frequencies as listed in the table

below. These notch filters are passive components and should not be used with +12

volts to prevent damage to the units. The filters also do not pass DC voltages.

155A

Part number Description

dB loss/gain

loss

ohms

Status

@ 474 MHz @ 614 MHz

2006947-001 2:1 Splitter/combiner – 4.8 – 4.8 0.2 Obsolete

2006947-002 4:1 Splitter/combiner – 8.4 – 9.1 0.2 Obsolete

2006947-003 8:1 Splitter/combiner – 15.0 – 13.1 0.2 Obsolete

2007753-001 2:1 Splitter/combiner – 3.5 – 3.9 0.1 Obsolete

2007753-002 4:1 Splitter/combiner – 7.3 – 7.5 0.1 Obsolete

2007753-003 8:1 Splitter/combiner – 10.9 – 10.5 0.1 Obsolete

2007753-014 2:1 Splitter/combiner – 3.5 – 3.6 0.02 Current

2007753-015 4:1 Splitter/combiner – 6.9 – 7.0 0.02 Current

2007753-016 8:1 Splitter/combiner – 10.25 – 10.5 0.07 Current

Part number Description

dB loss/gain

loss

ohms

Status

@ 474 MHz @ 614 MHz

17101-110 Passive Attenuator

(10 dB loss)

10.2 10.6 0.2 Current

401240-001 Passive Attenuator (3

dB loss)

3.1 3.1 0.2 Current

401241-001 Passive Attenuator (6

dB loss)

6.2 6.4 0.2 Current

GE ApexPro Technical Manual

Other manuals for GE ApexPro