March 2008
1-64 Programming Site Data
Activating Security (cont.) IMPORTANT: Since the default password is printed in this manual,
a new password should be entered. If the password is
ever lost, contact the factory for assistance.
6. Enter the New Password and press
[ENT]. Any combination of
letters and numbers up to a total of 21 characters may be used as a
password.
Note: Keep in mind that the password may have to be entered
frequently from the keypad. A long and/or complex password
may soon become annoying to use.
7. Verify the New Password by entering it again and press
[ENT]. Be
sure to record the new password in a safe place.
8. At the Lockout Level prompt, press
[F1] to lock only the PROG, CAL,
CLR
and LOG menus, or press [F2] to lock all the keys except
[PROG].
Procedure Options You have completed entering data in the Global Program. Continue
as follows:
• To continue programming the meter, refer to the menu maps in
Appendix A and navigate to the desired menu. Then, proceed to
the appropriate section of this manual for instructions.
• To leave the Global PROGRAM and retain the previous settings, press
[EXIT] twice and then press [F1] = NO at the SAVE prompt. Any
programming changes will be discarded and you will be returned
to the data display.
• To leave the Global PROGRAM and return to measurement mode,
press
[EXIT] twice and then press [F2] = YES at the SAVE prompt. Your
programming changes will be entered into the meter’s memory,
and you will be returned to the data display.
To Next Page
Loading...
Need help?
General
