GE DigitalFlow DF868 User Manual

Logging Data 3-5
March 2008
END TIME Prompt 12.Press [F1] to accept the displayed End Time or press [F2] to enter a
different end time. To select a specific time period for the log to
run, press
[F3].
• If OK was selected, proceed to the END DATE prompt.
• If TIMED was selected, proceed to the LOG TIME prompt.
• If EDIT was selected, complete the steps below.
Note: The log
END TIME must exceed the log START TIME by at least
five minutes. Failure to observe this restriction will result in
an error message.
a. Press
[F1] for AM or press [F2] for PM. Then, enter the desired
Hour and press
[ENT]. The acceptable range is 1 to 12.
b. Enter the desired Minutes and press
[ENT]. The acceptable
range is 0 to 59.
c. Enter the desired Seconds and press
[ENT]. The acceptable
range is 0 to 59.
END DATE Prompt 13.Press [F1] to accept the displayed End Date or press [F2] to enter a
different end date. To end the log today, press
[F3].
• If OK or TODAY was selected, proceed to the TIME INCREMENT
prompt.
• Otherwise, complete the steps below.
a. Enter the desired Year and press
[ENT]. The acceptable range is
0 to 99.
b. Use the [←], [→] and
[F1]-[F4] keys to select the desired
Month.
c. Enter the desired Day and press
[ENT]. The acceptable range is
1 to the number of days in the selected month (28, 29, 30 or
31). The program proceeds to step 15.
DURATION Prompt If a circular log was specified, the programming sequence continues
here after the log start time and/or start date is entered.
14.Press
[F1] and enter a log Duration in hours or press [F2] and enter
a log duration in days. Press
[ENT], and go to step 16.

GE DigitalFlow DF868 Specifications

General

Brand	GE
Model	DigitalFlow DF868
Category	Measuring Instruments
Language	English