NX-10 Installers manual
153
2. Select Program KP Text, press OK, and then select a language using the ½¾ keys.
3. Scroll to Zones/Messages>Custom Message, press OK, and then edit the appropriate line
of the message.
4. Press OK. The keypad beeps once to accept the change and returns to Custom Message.
Edit the other line of the message, if required.
Setting the keypad partition and keypad number
When you first power up the keypad, you are prompted to set the language, the default country and
the partition and keypad number for the current keypad. The keypad can connect to the bus only after
you set these numbers. The partition number and keypad number prompts are displayed for the initial
setting only. To change these numbers again, scroll to This Keypad>Partition Number and This
Keypad>Keypad Number.
Setting the exit buzzer options
You can configure a behaviour of the warning signal emitted during the exit delay, when the user is
leaving premises. The menu entries responsible for the keypad buzzer are partially located in the
Partition Settings and System Settings groups of the Control Panel menu. These settings affect all the
keypads in the system or all the keypads in the partition. For example to cancel the keypad exit
buzzer completely for all the keypads:
1. Navigate with the ½¾ keys to Control Panel and press OK.
2. Scroll to System Settings>Feature Select>Miscellaneous>Silent Exit Always.
3. Use the ½¾ keys to change the status to Yes and press OK.
4. The keypad beeps once to accept the change and returns to Silent Exit Always.
You can also silence the particular keypad. The following options cancel the exit buzzer and chime
on the current keypad only:
1. Navigate with the ½¾ keys to This Keypad and press OK.
2. Select Keypad Features>Silent Keypad and press OK.
3. Use the ½¾ keys to change the status to Yes and press OK.
4. The keypad beeps once to accept the change and returns to Silent Keypad.
To set advanced buzzer options for the keypad on partition 1, when exit delays are set to 20 seconds
and 10 seconds respectively:
1. Navigate with the ½¾ keys to Control Panel and press OK.
2. Scroll to Partition Settings>Partition 1>Timers>Exit Time 1 and press OK.
3. Type 20 and press OK.
4. The keypad beeps once to accept the change and returns to Exit Time 1.
5. Scroll to Partition Settings>Partition 1>Timers>Exit Time 2 and press OK.
6. Type 10 and press OK.
7. The keypad beeps once to accept the change and returns to Exit Time 2.
8. Navigate with the ½¾ keys to This Keypad and press OK.
To Next Page
Loading...
Need help?
General
