GE NX-10 Installer Manual

NX-10 Installers manual
253
Appendix 5: Tasks summary
Users with different rights are allowed to perform different tasks in the system. Table 45 System tasks
lists each task. Black fields indicate tasks that cannot be performed at the particular level, while white
fields indicate allowed actions. Checkmarks denote tasks that can be performed conditionally, and
conditions required are explained in the Condition column.
Table 45. System tasks
Task Installer Master user User No code Condition
Adjusting the LCD contrast
Answer an up/download
call
*
* If the 2.4.2.7 Require Code for
Download menu option is set to No.
Arm and disarm the
system
* * **
* If authority allows (see settings in
the Authority menu group).
** If the keypad is in a single-
partition mode, and the 2.5.2.1.1
Quick Arm menu option is set to Yes,
you can arm without entering the
user code, just by pressing the F3, F4
or F7 function key.
Bypass a zone
* * *
* If authority allows (see settings in
the Authority menu group).
Configure home
automation devices
Control home automation
devices
Engineer tamper reset
*
* If enabled for master users., i.e. if
the 2.6.2.4.2 Master Code Resets
Tamper Memory menu option is set
to Yes.
Initiate an up/download
call
*
* If enabled for use without a code,
i.e. if the 2.4.2.7 Require Code for
Download menu option is set to No.
Perform a configured test
Perform a service check
Perform a walktest
Program voice phone
numbers
* *
* If the 3.1.6 User Phone Editing
menu option is set to Enabled.
Reset fire detector
Set system date and time
Set user authority level
Set user codes
*
* Only own code, Duress Code and
GuardCodes 16 17.
Switch between master
mode and single-partition
mode
View the alarm memory
View the event log

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English