GE NX-10 Installer Manual

NX-10 Installers manual
45
by default and events for phone numbers 2 - 3 are disabled by default. If phone number 1 and phone
number 2 are programmed, the default sequence is 1,1 2,2 1,1,2,2 for a total of eight calls to each
number.
Table 8. Backup reporting
Level 1 Level 2 Value State
Phone Number Phone Number 1 123456
Phone Number 2 456789
Account Code Phone Number 1 BE5566
Phone Number 2 445566
Protocol Phone Number 1 SIA
Phone Number 2 SIA
Events Phone Number 1 – Alarms Enabled
Phone Number 1 – Alarm Restores Enabled
Phone Number 1 – Tampers and Restores Enabled
Phone Number 2 – Alarms Disabled
Phone Number 2 – Alarm Restores Disabled
Phone Number 2 – Tampers and Restores Disabled
Dual reporting
Dual reporting configures the control panel to report to two different central stations. Events must be
reported to both phone numbers. The control panel dials the first number twice. If it cannot reach this
number, it dials the second number twice. It performs this sequence for the number of times specified
in Dial Attempts or until it reports the events to both numbers. The same account code is used to
report to both numbers. Events for phone number 1 are enabled by default and events for phone
number 2 are disabled by default.
Table 9. Dual reporting
Level 1 Level 2 Value State
Phone Number Phone Number 1 123456
Phone Number 2 456789
Account Code Phone Number 1 BE5566
Phone Number 2 445566
Protocol Phone Number 1 SIA
Phone Number 2 SIA

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English