To Next Page

To Previous Page

Reporting events to phone number 2

Phone N°2 can be used to back up phone N°1, or as a second receiver to multi-report or split-report

events. Phone N°2 has two programming locations that are used to select the events that are reported

to this phone number. Location 10 is used to select the events which are reported to phone N°2, and

location 11 is used to select which partitions are reported to phone N°2. If you do not want dual or

split reporting, location 10 and location 11 should be left at the factory default of “0”. If you want

multi-reporting or split reporting, and the split is based on the event type (such as alarm, open close

etc.), location 10 should be used to select only those events that should be reported to phone N°2, and

location 11 should be left at the factory default of “0”. If you want dual or split reporting, and the

split is based on partition, then location 10 should be programmed as “0”, and location 11 should be

used to select those partitions that are to be reported to phone N°2. If no events are to be reported to

phone N°2, both locations should be at “0”.

LOCATION 10 - EVENTS REPORTED TO PHONE N° 2 (2 segments of feature selection data)

Segment 1

1 = Alarms

2 = Opening and closings

3 = Zone bypass and bypass restores

4 = Zone trouble and trouble restores

5 = Power fail (AC failure), low battery, power restore (AC restore) , and low

battery restore

6 = Bell cut, bell cut restore, telephone line restore

7 = Test reports

8 = Start and end programming, download complete and log full

Segment 2

1 = Zone and box tamper

2 = Auxiliary power overcurrent, and restore

3 = Wireless sensor missing and restore

4 = Wireless sensor low battery and restore

5 = Expander trouble and restore (keypads are considered as expanders)

6 = Fail to communicate

7 = Alarm restore

8 = Tamper restore

LOCATION 11 - PARTITIONS REPORTED TO PHONE N° 2 (1 segment, feature selection data)

Location 11 is used when events to be reported to a phone number are based on the partition,

regardless of the event. If this location is used, location 10 should be “0”.

Segment 1

1 = Partition 1

2 = Partition 2

3 = Partition 3

4 = Partition 4

GE NX-10 Installer Manual

Other manuals for GE NX-10