Program execution mode 15
Cod. 523340
Rev. 10/1016
4.4. Unbalance control
Before starting the spin, the washing machine’s electronic control checks the correct distribution of the load.
If it detects that the load is not well distributed and that can cause an excessive unbalance during the spin, the
linen will be repositioned.
If there is still unbalance during the final phase spin, the washer can end the washing cycle at a reduced spin
speed.
Unbalance control with a micro-switch (HS/EH models only). It is only activated in cases of extreme unbalance.
To improve the efficiency of the washer’s spin, it is advisable to:
Load the washer up to its nominal value.
Load the washer with homogeneous loads.
4.5. Loading the washing machine
Group the fabrics to be washed into homogeneous loads, attempting wherever possible to reach the nominal
value of the load. Empty all pockets, fasten buttons, close zippers and remove accessories that are not machine-
washable. Mixing whites with other colours is not recommended.
Open the door and load the machine.
Washer load recommendations according to the type of fabric to be washed:
- Cotton fabrics: nominal load
- Synthetic fabrics: between 80% & 90% of nominal load
- Delicate fabrics: between 35% & 50% of nominal load
Do not overload the machine; the door must be able to close easily.
Whilst the door is open, the display reads door indicating that the door must be closed in order for the program
to begin.
Health and safety instructions for loading and unloading the washer
Installing washing machines on raised bases or pedestals, in accordance with the instructions set out in the
corresponding installation manuals, aids in loading and unloading the machine by avoiding the need to adopt
awkward positions.
Use linen collecting and transporting containers that are of a suitable height for the washer size. Consult the
dimensions of the washers set out in the corresponding installation manual.
Take care not to overload the machine. Overloading the washer leads to excessive strain when processing the
linen.
Certain chemical products that are used in the washing process are toxic. Handle them with care and wear
appropriate protection.
Follow the legislation and regulations for Health and Safety in the Workplace in force in the country where the
machine has been installed.
To Next Page
Loading...
Need help?
General
