GIRBAU LOGI CONTROL User Manual

LOGI PRO. Advanced mode 55
Cod. 523340
Rev. 10/1016
8. LOGI PRO. ADVANCED USE MODE
There is an ADVANCED USE mode: This mode includes five different menus by means of which each user can
personalise the operation of the washing machine.
8.1. ADVANCED MODE menus
MENU
PURPOSE
Pro
Programming menu. Modification of the program contents
INFO
Information menu
Mod
Modification of the general operating parameters menu
Ncod
Modification of the access code menu
HOUR
Adjustment of the system time menu
8.2. Access to ADVANCED MODE
Connect the washer and open the door. The display will show door.
Hold down the key until the display shows Cod.
Enter the access code into the menus by pressing the sequence of eight keys of the code without interruption.
In basic configuration (factory set) the code to access the ADVANCED USE MODE is: 12341234
Numerical correspondence of each key
KEY
CORRESPONDENCE
1
▲
2
3
▼
4
If the sequence entered is correct, the display will show Pro, corresponding to the first menu.
The ▲/▼ keys allow the user to select the precedent table menus. The menu selected is shown on the display
following its keyword. To enter the menu, press the key when displaying it.
If you wish to skip the ADVANCED USE MODE, press START/STOP and the machine will return to the
program execution mode.
8.3. Modifying the contents of programs. Menu Pro
In its original configuration the washer presents the first eight programs with a content adapted to a broad sector
of use.
The content of the remaining programs is the same in all the phases.
The content of each program can be modified to adapt it to specific needs of different areas.
The modifications are always made within the limits set by a PROGRAMMING VECTORS that includes the
possible programmable parameters and the maximum and minimum values of certain options.
At the start of each phase, a parameter of the value Ph-Y / Ph-N (executable phase YES / executable phase
NO) will allow the user to determine whether the accessed phase should either be executed or omitted.
Once the phase is defined as to be executed, proceed to the display and modification (if desired) of the
parameters or values of the phase.
In the LOGI PRO CONTROL, the programmable values are the same in all the phases of all the programs.
Phase 11 is always of obligatory execution since it defines the end of the program.

GIRBAU LOGI CONTROL Specifications

General

Brand	GIRBAU
Model	LOGI CONTROL
Category	Controller
Language	English