GIRBAU LOGI CONTROL User Manual

Withdrawing from service 81
Cod. 523340
Rev. 10/1016
11. WITHDRAWING FROM SERVICE
 Removing the washer from service requires a specialised company.
 Never release the washer unsecured.
 To release the washer and carry out subsequent transportation, refer to the same specifications
and cautions indicated for Installation.
When removing the machine from service:
 Disconnect and mechanically lock the external switch. Remove the supply cables.
 Close and mechanically interlock the manual water supply valves. Remove the water supply hoses.
 Disassemble the drain outlet pipe and empty any residual water left in the washing machine.
 Assemble the shipping restraints.
 Dismantle the door of the washing machine (consult the Authorised Technical Service).
Dismantling
Most of the machine’s components are made of recyclable or recoverable materials.
The injected pieces bear information on the materials that were used to make them.
The main materials are:
 Steel plates
 Stainless steel plate
 Grey cast iron
 Aluminium
 Glass
 Polypropylene (PP)
 Ethylene Propylene (EPDM)
 ABS
 Copper
 Electronic components
Management of waste from electronic devices
In compliance with Directive 2002/96/EC on the management of waste from electronic devices, it
is the obligation of the manufacturer to warn that:
The electronic components installed in the washing machine, must be dismantled and delivered
to treatment facilities authorised for this purpose.

GIRBAU LOGI CONTROL Specifications

General

Brand	GIRBAU
Model	LOGI CONTROL
Category	Controller
Language	English