Troubleshooting 72
Cod. 523340
Rev. 10/1016
INFORMATION COMMON TO BOTH LOGI CONTROL AND LOGI PRO
CONTROL
9. TROUBLESHOOTING
9.1. Freeing a trapped person
PROCEDURE IN THE EVENT OF ENTRAPMENT OF A PERSON OR AN ANIMAL
INSIDE THE WASHER
1. Press the START/STOP key. This action interrupts the wash cycle in operation and opens the washing
machine drain. The washing machine control circuit remains in operation.
2. Open the door. After the bath has been drained and the drum rotation has ended, the door lock is
unblocked allowing the door to be opened.
3. If the door fails to release: Consult the following sections: Dismantling the door of the washing
machine, or Manual realising of the safety lock (sections 9.2 and 9.3)
CAUTION! If instead of pressing the START/STOP key you perform one of the following
actions THE DOOR LOCK WILL NOT BE RELEASED immediately:
Pressing the EMERGENCY STOP
Disconnecting the ON/OFF switch
Disconnecting the SWITCH DISCONNECTOR
9.2. Manual releasing the safety lock
WARNING:
This procedure is recommended in problems caused by a
failure to realise the door of the machine. It should only be
carried out by the Authorised Technical Service except in
emergency situations.
Specific information for HS-6023, HS-6024, EH055, EH060,
RMS/RMG628, REM/RMG070 models.
Before disassembling the door of the washing machine:
Check that the bath level does not exceed the door opening
level.
Close and mechanically interlock the manual water supply
valves.
Close and mechanically lock the manual steam inlet valve
(steam heated washing machines)
Disconnect and mechanically lock the External Automatic
Switch or the of the washing machine disconnector switch.
In order to release the safety lock manually, completely insert a rod
with a diameter of 0.2 inches (3 mm) and an approximate length of
4 inches (100 mm)into the bottom side of the safety lock cover, and
at the same time turn the knob downwards (Fig. 9.3).
To Next Page
Loading...
Need help?
General
