LOGI CONTROL. Advanced mode 28
Cod. 523340
Rev. 10/1016
6. LOGI CONTROL. ADVANCED USE MODE
There is an ADVANCED USE mode: This mode includes five different menus by means of which each user can
personalise the operation of the washing machine.
6.1. ADVANCED MODE menus
6.2. Access to ADVANCED MODE
Connect the washer and open the door. The display will show door.
Hold down the key until the display shows Cod.
Enter the access code into the menus by pressing the sequence of eight keys of the code without interruption.
In basic configuration (when the machine is delivered) the code for accessing ADVANCED mode is: 12341234.
Numerical correspondence of each key
If the sequence entered is correct, the display will show Pro, corresponding to the first menu.
The ▲/▼ keys allow the selection of ADVANCED MODE menus. The menu selected is shown on the display
following its keyword. To enter the menu, press the key when displaying it.
If you wish to skip the ADVANCED mode, press START/STOP and machine will return to the programs
execution mode.
6.3. Modifying the contents of programs. Menu Pro
In its original configuration, the washing machine has eight wash programs with content adapted to a wide
range of usage. However, the content of each program can be modified to be adapted to the specific needs of
different situations.
Modifications will always be carried out within the limits marked by PROGRAMMING VECTORS (see Section
6.5.1) which include the possible programmable parameters and the maximum and minimum values of certain
options.
The master program is composed of nine phases. At the start of each phase, a parameter of the value Ph-Y /
Ph-N (executable phase YES / executable phase NO) will allow the user to determine whether the accessed
phase should either be executed or omitted.
Once the phase is defined as to be executed, proceed to the display and modification (if desired) of the
parameters or values of the phase.
Note: (UK setting only) Program 3 cannot be modified.
To Next Page
Loading...
Need help?
General
