Caution
The users must refrain from carrying out actions reserved for the Authorised Technical
Services.
Before performing any work on the washing machine, disconnect and mechanically lock the
external switch, and close and mechanically lock the manual water inlet valves.
Check that the temperature of the parts to be handled represents no risk of burns.
The dispenser may contain residues of chemical products. In cleaning operations, avoid direct
contact with the skin and protect the eyes.
The draining pump and valve may contain residual water. When handling these components,
avoid direct contact with the skin and use eye protection.
Remember to reassemble ALL of the panels and replace them correctly after any maintenance
work.
It is highly recommended to ask the Authorised Technical Service for a register or report of all
the maintenance and service work done on your washer.
Operations described
USER-MAINTENANCE INSTRUCTIONS
Cleaning the washer (Section 10.1)
Cleaning the door seal (Section 10.2)
Cleaning the solenoid valve filters (Section 10.3)
Checking safety devices (Section 10.4)
ONLY TO BE PERFORMED BY THE AUTHORISED TECHNICAL SERVICE
Cleaning the dispenser (Section 10.5)
Cleaning the drain pump (Section 10.6)
Checking the condition of the bearing housing seals (Section 10.7)
General overhaul (Section 10.8)
10.1. Cleaning the washer
We recommend cleaning the outside of the washing machine periodically. Use a damp cloth or sponge.
To remove grease marks use a neutral soap and rinse well.
Never use aggressive products, solvents, abrasive scourers or tools that may scratch or deteriorate the
external surface of the washing machine.
10.2. Cleaning the door seal
Use a cloth or sponge moistened in water.
Be especially careful to remove traces of laundry products or pieces of fabric that could be caught between
the folds of the seal.
Never use abrasive products or tools that could cut or damage the seal.
To Next Page
Loading...
Need help?
General
