Program execution mode 19
Cod. 523340
Rev. 10/1016
4.8. Modifying a program in progress
4.8.1. Program acceleration
You can modify the duration of a program whilst it is in progress.
Press the key to activate the option. The display will flash.
Pressing the key repeatedly increases the rotation times minute by minute. The duration of the spin
cycle cannot be increased.
Pressing the key repeatedly decreases the rotation or spin times.
Moving on to the subsequent phase. Moving on from one phase to the next is delayed. Press the key
until the end of the phase and wait a few moments until the first operation of the next phase appears.
Continue pressing the key.
After a few seconds without pressing any key the display will remain fixed and the modification option is
deactivated.
Important: (UK only) The duration of the bath filling phase in Program 3 cannot be altered.
4.8.2. Crease-guard stop
A function exclusive to LOGI CONTROL
Once the washing program has started, you can program the drum rotation to stop before the final spin, with the
objective of avoiding creases.
To activate this function once the washing cycle has started, press the key for a few seconds. The message
rh-0 will appear on the display. Press the key. The display message will change to rh-I. The crease-guard
Stop function has been activated.
Before the final spin, the drum rotation will be interrupted and the PUSH/ STAR message will appear on the
display. To resume the program, press the key.
4.9. DELAY option
The DELAY option allows you to program the start time of a program depending on the needs of the user. For
example: to use two-rate electricity, to rationalise electricity consumption, to adjust the laundry production
system, etc.
To use the DELAY option (start program delay) it is essential that the washing machine has the
clock installed that allows operating in real time. If this option is not incorporated originally, it can be
easily installed. Contact your dealer.
Before the first use, and each time there is a time change, verify and/or adjust the time on the clock.
(See ADVANCED USE MODE) Sections 6.9 and 8.9.
To Next Page
Loading...
Need help?
General
