GIRBAU LOGI CONTROL User Manual

LOGI CONTROL. Advanced mode 41
Cod. 523340
Rev. 10/1016
6.7.2. Summary table of the changeable parameters Applicable only in the United Kingdom
PARAMETER
MODIFICATION OF
OPTIONS
CE
USA
b
Buzzer
b-0
Without buzzer
b-1
Low buzzer
b-2
Normal buzzer


b-3
Strong buzzer
dt
Information on the
display during a
program
dt-0
Functions display


dt-1
Program time remaining display
C / F
Temperature unit
C
Temperature displayed in degrees Celsius

F
Temperature displayed in degrees Fahrenheit

dc
Cleaning the
dispenser
dc-0
Dispenser cleaning NO activated


dc-1
Dispenser cleaning YES activated
AC
Program acceleration
AC-0
Without acceleration permission
AC-1
With acceleration permission


tS
Wash temperature
selection when
starting program
tS-0
Wash temperature selection disabled
tS-1
Wash temperature selection enabled


JL
Automatic weighing
system (notes 1 and
2)
JL-0
Option disabled


JL-2
Option enabled
dL
Proportional dosing
time (notes 1 and 2)
dL-0
Option disabled


dL-1
Option enabled
Pg
Hot water purge
(note 3)
Pg-0
Purge option disabled


P250
Maximum purge time: 250 sec.
Pd
Purge drain
selection.
(note 4)
Pd-2
Purge water outlet via normally opened drain
valve


Pd-3
Purge water outlet via normally closed drain
valve or pump.
Id
Network identifier
Id-0
Disabled communication


Id-1..99
Enabled communication
 Indicates default option following configuration.
Note 1: The weighing system is only applicable to HS models (Programs: 2, 3, 4 and 7).
Note 2: The automatic weighing system is not applicable to model HS-6024.
Note 3: Except models HS-6008 & RMS610.
Note 4: Option available only on models with a double drainage kit installed on the machine and activated on
the configuration menu.

GIRBAU LOGI CONTROL Specifications

General

Brand	GIRBAU
Model	LOGI CONTROL
Category	Controller
Language	English