HEIDENHAIN TNC 426 B User Manual

185HEIDENHAIN TNC 426 B, TNC 430
8.4 Cycles for Machining Hole Patterns
The TNC provides two cycles for machining hole patterns:
Cycle Soft key
220 CIRCULAR PATTERN
221 LINEAR PATTERN
You can combine Cycle 220 and Cycle 221 with the following fixed
cycles:
Cycle 1 PECKING
Cycle 2 TAPPING with a floating tap holder
Cycle 3 SLOT MILLING
Cycle 4 POCKET MILLING
Cycle 5 CIRCULAR POCKET MILLING
Cycle 17 RIGID TAPPING
Cycle 18 THREAD CUTTING
Cycle 200 DRILLING
Cycle 201 REAMING
Cycle 202 BORING
Cycle 203 UNIVERSAL MILLING CYCLE
Cycle 204 BACK BORING
Cycle 212 POCKET FINISHING
Cycle 213 STUD FINISHING
Cycle 214 CIRCULAR POCKET FINISHING
Cycle 215 CIRCULAR STUD FINISHING
8.4 Cycles for Machining Point Patterns
kkap8.pm6 30.06.2006, 07:03185
www.EngineeringBooksPdf.com

HEIDENHAIN TNC 426 B Specifications

General

Brand	HEIDENHAIN
Model	TNC 426 B
Category	Control Systems
Language	English