HEIDENHAIN TNC 426 B User Manual

HEIDENHAIN TNC 426 B, TNC 430
245
9.5 Nesting
Repeating a subprogram
Example NC blocks
0 BEGIN PGM UPGREP MM
...
10 LBL 1
11 CALL LBL 2
12 CALL LBL 1 REP 2/2
...
19 L Z+100 R0 FMAX M2
20 LBL 2
...
28 LBL 0
29 END PGM UPGREP MM
Program execution
1st step: Main program UPGREP is executed up to block 11.
2nd step: Subprogram 2 is called and executed.
3rd step: Program section between block 12 and block 10 is
repeated twice. This means that subprogram 2 is
repeated twice.
4th step: Main program UPGREP is executed from block 13 to
block 19. End of program.
Beginning of the program section repeat
Subprogram call
The program section between this block and LBL1
(block 10) is repeated twice
Last program block of the main program with M2
Beginning of subprogram
End of subprogram
LKAP9.PM6 30.06.2006, 07:04245
www.EngineeringBooksPdf.com

HEIDENHAIN TNC 426 B Specifications

General

Brand	HEIDENHAIN
Model	TNC 426 B
Category	Control Systems
Language	English