HEIDENHAIN TNC 426 B User Manual

7HEIDENHAIN TNC 426 B, TNC 430
1.4 Status Displays1.4 Status Displays
Program Run, Full Sequence and
Program Run, Single Block
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or to a manual or
programmed stop. You can resume program run after an
interruption.
In the Program Run, Single Block mode of operation you execute
each block separately by pressing the machine START button.
Soft keys for selecting the screen layout
Screen windows Soft key
Program
Left: program blocks, right: program structure
Left: program blocks, right: STATUS
Left: program blocks, right: graphics
Graphics
1.4 Status Displays
“General” status display
The status display informs you of the current state of the machine
tool. It is displayed automatically in the following modes of
operation:
■
Program Run, Single Block and Program Run, Full Sequence,
except if the screen layout is set to display graphics only, and
■
Positioning with Manual Data Input (MDI).
In the operating modes Manual and Electronic Handwheel, the
status display is shown in the large window.
Dkap1.pm6 30.06.2006, 07:037
www.EngineeringBooksPdf.com

HEIDENHAIN TNC 426 B Specifications

General

Brand	HEIDENHAIN
Model	TNC 426 B
Category	Control Systems
Language	English