17HEIDENHAIN TNC 426 B, TNC 430
Incremental jog positioning
With incremental jog positioning you can move a machine axis by a
preset distance.
Select Manual or Electronic Handwheel mode
of operation
<
Select incremental jog positioning: Switch the
INCREMENT soft key to ON
Jog increment =
<
Enter the jog increment in millimeters
(here, 8 mm).
<
Press the machine axis direction button as often
as desired.
2.3 Spindle Speed S, Feed Rate F and
Miscellaneous Functions M
In the operating modes Manual and Electronic Handwheel, you can
enter the spindle speed S, feed rate F and the miscellaneous
functions M with soft keys. The miscellaneous functions are
described in Chapter 7 ”Programming: Miscellaneous Functions.”
16
X
Z
8
8
8
2.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M
Dkap2_3.pm6 30.06.2006, 07:0317
www.EngineeringBooksPdf.com
To Next Page
Loading...
Need help?
General
