User Manual of Digital Video Recorder
215
11.11 Configuring HDD Error Alarms
Purpose:
You can configure the HDD error alarms when the HDD status is Uninitialized or Abnormal.
Steps:
1. Enter the Exception interface.
Menu > Configuration > Exceptions
2. Select the Exception Type to HDD Error from the drop-down list.
3. Click the checkbox(s) below to select the HDD error alarm type (s).
The alarm type can be selected to: Audible Warning, Notify Surveillance Center, Send Email and
Trigger Alarm Output. Please refer to Chapter 8.7 Setting Alarm Linkage Actions.
Figure 11. 34 Configure HDD Error Alarm
4. When the Trigger Alarm Output (not supported by DS-7200 series) is selected, you can also select the alarm
output to be triggered from the list below.
5. Click Apply to save the settings.
To Next Page
Loading...
Need help?
General