User Manual of Digital Video Recorder
43
3.2 Operations in Live View Mode
In live view mode, there are many functions provided. Some of the functions are listed below.
• Single Screen: showing only one screen on the monitor.
• Multi-screen: showing multiple screens on the monitor simultaneously.
• Auto-switch: the screen is auto switched to the next one. And you must set the dwell time for each screen
on the configuration menu before enabling the auto-switch.
Menu>Configuration>Live View>Dwell Time.
• Start Recording: start all-day normal recording or motion detection recording for all channels.
• Add IP Camera: the shortcut to the IP camera management interface (only supported by HDVR series)
• Playback: play back the recorded videos for current day.
• Output Mode: select the output mode to Standard, Bright, Gentle or Vivid.
• Aux Monitor: the device checks the connection of the output interfaces to define the main and auxiliary
output interfaces. See the table below for the priority level of the main and aux outputs.
Table 3. 2 Priorities of Outputs for DS-9200/9100/9000/8100/8000HWI-ST & DS-7200 Series
√ means the interface is in use, × means the interface is out of use or the connection is invalid. And the
HDMI, VGA and CVBS can be used at the same time.
When the aux output is enabled, you can do some basic operation in the live view mode for the Aux output,
while no operation is allowed for the main output.
3.2.1 Front Panel Operation
Front panel operation is not supported by 7200HWI-SV series.
Table 3. 4 Front Panel Operation in Live View
To Next Page
Loading...
Need help?
General