User Manual of Digital Video Recorder
76
5.4 Configuring Alarm Triggered Recording
and Capture
Purpose:
Follow the procedure to configure alarm triggered recording or capture.
Sensor alarm is not supported by DS-7200HWI-SV series. We use the interface of DS-9100HFI-ST series
(unless otherwise stated) as example to describe the following settings.
Steps:
1. Enter the Alarm setting interface.
Menu > Configuration > Alarm
Figure 5. 22 Alarm Settings
2. Click Alarm Input tab.
Figure 5. 23 Alarm Settings- Alarm Input
1) Select Alarm Input No. and configure alarm parameters.
2) Edit the alarm name as desired and choose N.O (normally open) or N.C (normally closed) for alarm
type.
3) Check checkbox to enable the alarm input.
4) Click to configure the alarm settings.
To Next Page
Loading...
Need help?
General