G. Other LCD Indications
Indication in Normal Condition
<EMERGENCY>
The "EMERGENCY" is indicated when the emergency stop signal
is input by the outside input function.
During the emergency stoppage, indoor units are stopped and the
operation by the remote control switch is not available.
Contact your distributor or dealer of Hisense for details.
<DEMAND>
The "DEMAND" is indicated when the demand input is set by
the outside input function.
The indication is indicated for the group with demand setting and
the "DEMAND" indication fl
ickers when the demand signal is
input.
Contact your distributor or dealer of Hisense for details.
<FILTER>
Filter Clogging:
When the "FILTER" indication is indicated, it shows that the air
fi lter of the indoor unit is clogged. Clean the air fi lter.
After cleaning, depress the "RESET" switch and the "FILTER"
indication is turned OFF.
Indication in Abnormal Conditions
<ABNORMAL>
a. The Run lamp (Red lamp) is fl ickered when there is a group in
abnormal condition.
b.
The "ALARM" is indicated on the LCD.
c. The "
!
" indication of the zone and the group in abnormal
condition is fl ickered.
d. Depress the "ZONE" switch and the "GROUP" switch and
select the group with alarm, the indication of unit No., model
code, alarm code and the normal indication is repeatedly
indicated (There is a case that the model code may not be
indicated according to the unit model).
e. In case that multiple units are in abnormal conditions, the
above indication is indicated by turns.
Check the contents of the LCD indication and contact your
distributor or dealer of Hisense for details.
<POWER FAILURE>
a. All the indications are disappeared.
b. In case of unit stoppage due to the power failure, the unit is not started again after the power recovery. Perform
the starting operation again.
c. In case of instant power failure within 2 seconds, the unit is automatically started again.
<ELECTRICAL NOISE>
All the indications are disappeared, and the unit operation may be stopped for the device protection due to
the electrical noise. Perform the starting operation again
Turned ON
Turned ON
Flickering
Turned ON
Ref. No. I.U. Add.
Model Code
Alarm Code
Flickering
Turned ON
In Case of Demand Setting
In Case of Demand Signal Input
HYJE-D02H
143
To Next Page
Loading...
Need help?
General
