Honeywell Enhanced Micro TDC 3000 User Manual

Enhanced Micro TDC 3000 User’s Manual 2-20 9/95
2.8.3
2.8.3 Optional Computer Gateway CLI I/O
The optional computer gateway adds one or two connections to a host computer.
1. Remove the rear center-section cover of tower #2 and connect the computer cable
(503790-xxx) to
JA of the CLI I/O board (see Figure 2-16). Use a small screwdriver to
tighten the screws (2) on the connector.
The tab number (-xxx) in the cable drawing number refers to its length in meters. The
maximum cable length is 305 meters (1000 feet).
I/O CLI
RS-449
80360230-001
JB JA
Figure 2-16 — CLI I/O Board
2. If the host computer is running in a redundant mode, an additional cable must be
connected from the computer to JB of the CLI I/O board (see Figure 2-16). Use a small
screwdriver to tighten the screws (2) on the connector.
3. Using a cable-tie (51190879-001) on each cable, fasten the cables to their strain-relief
clamps (marked OPTIONS in Figure 2-7) on the lower transition panel.

Honeywell Enhanced Micro TDC 3000 Specifications

General

Brand	Honeywell
Model	Enhanced Micro TDC 3000
Category	Controller
Language	English