Enhanced Micro TDC 3000 User’s Manual 2-24 9/95
2.10
2.10 INSTALLATION WRAP-UP
1. Check to see that all signal cables and coaxial cables entering towers are properly
secured to the rear of the towers by strain-relief clamps or connector screws. Install the
rear covers with star washers on both towers.
2. If you have not already done so, dress signal and power cables neatly, at the rear of the
system, so that they will not be a personnel hazard. Dress cables that leave the area to
connect to UCN taps, etc., so they will not be stepped-on or damaged in any way.
3. Gather packing material, boxes, and pallets and remove them from the operations room.
Temporarily store the shipping boxes in the event something must be returned to the
factory.
4. Clean and tidy the operations room to keep operating media (cartridge disks) from
being unduly exposed to dust and foreign material.
5. Check each cartridge slot of the cartridge drives. If there are polystyrene shipping
inserts in the slots, carefully remove them.
6. Make sure the power switches on both towers, the color monitor(s), and the printer are
all
OFF.
7. Plug power cords from all units into the proper receptacles for the power required.
8. Continue on to Section 3 for power-up tests and other checkout procedures.
To Next Page
Loading...
Need help?
General
