Galaxy Flex Installer Manual Quick Menu [59]
157
Quick Menu [59]
The quick menu consists of up to ten menu options that are accessed by all type 3 user codes
and above that do not have a
assigned to their code type. You can reprogram the quick
menu to include any menu options. The default settings are shown in the following table:
Quick
Menu No.
Menu Option User
Type
0 Omit Zones [11] 3
1 Chime [15] 3
2 Display Zones [21] 4
3 Display Log [22] 4
4 Print [24] 4
5 Walk Test [31] 5
6 Time/Date [41] 6
7 Codes [42] 1
8 Summer [43] 6
9 Eng. Access [48] 6
Modifying the Quick Menu
On selecting the Quick Menu option, the details of the first option assigned are displayed.
This includes the quick menu location, the assigned menu option, the full menu option
number and the assigned user type.
To modify the quick menu:
1. Type, or navigate to, a quick menu number, and then press ent.
2. Type, or navigate to, a full menu number (11 to 72), and then press ent.
To delete a quick menu option:
Press
instead of a full menu number. =NOT USED is displayed.
The system arranges the quick menu in order of lowest user type access required, therefore
if quick menu number 0 is assigned a menu option which is of a higher access type than
options 2, 3 and 4, the menu is rearranged and the display indicates that the option is now
number 4.
Note: You cannot assign duplicate quick menu options. The message DUPLICATE
ENTRY is displayed and the system prompts for a new option to be assigned.
0=OMIT ZONES
Option=[11] L=3
quick menu location
full menu option number
menu options
user type (user level)
To Next Page
Loading...
Need help?
General
