Galaxy Flex Installer Manual Group Omit [46]
61
Use the System Print Timers [57.11] option to print all of the programmed timers; Weekly
Schedule, Timer Outputs, and Autoset.
Holidays [45.2]
Use this function to allocate up to 4 holiday calendars.
Timers [45.3]
If Timer Access [51.43] is enabled these sub-options are available:
1=Name
2=Status
3=Events
4=Hol. Period
5=Hol. Sched
6=Pattern Day
For information on how to use these options refer to Weekly Schedule [65.1].
If Timer Access [51.43] is disabled, you can only change the programmed weekly timer
schedules status (either Off or On). All timer schedules default to Off.
Late Work [45.4]
Use this option to authorize an Autoset Extension in advance of the pre-warning period
(refer to Autoset [65.3]).
Note: Additional extensions can be authorized by entry of a valid code during the
subsequent autoset pre-warning periods.
Weekend Work [45.5]
The Weekend Work option allows a valid user code to authorize the system to unset at the
weekend.
Access Template [45.6]
An access template defines when and where a user is allowed access. For each access
template, a schedule is given to each group (area) to define when access to each group is
possible. Up to 20 templates are available per system. If no schedule is given to a group, the
user will have full access to the group.
Group Omit [46]
Use this option to block omit all the omittable zones that are open at the end of the confirm
time in a group or multiple groups. All zones in the required groups that have the omit
attribute enabled (refer to Omit [52.4]) are omitted when this option is selected. Groups can
be omitted and reinstated without setting and unsetting the system. You need type 6 status to
use this option.
To Next Page
Loading...
Need help?
General
