LS10143-001SK-E Network Management
6-4
To change an access code:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 6 for Network Programming Menu.
3. Select 5 for Access Codes.
Display reads: Select Profile 01
Fire Fighter’s Key
4. Select the access code you wish to edit by pressing the up or down arrow key.
5. Then press ENTER.
Profile Edit Menu
From the Profile Edit Menu you can change the users name, access code, and the panel functions that the user
will have access to with their code.
Note: Profile 1 (Fire Fighter’s Key) the user name and access code can not be edited. Profile 2 (Installer) the
user name and panel functions can not be edited. Profile 3 (Multi-Site Installer) is defaulted with the Multi-
Site access option, but the entire profile can be edited.
6.2.5.1 Edit Name
6. See Appendix B for a list of available characters and their numeric designators.
7. Then press ENTER to finish.
6.2.5.2 Edit Access Code
8. Enter new access code (minimum of 4 digits, maximum of 7 digit).
9. Press ENTER.
10. Enter code again. Press ENTER.
6.2.5.3 Panel Functions
11. Press the up or down arrow key to move through the list of available functions.
12. Then press right arrow to move to Y (yes) or N (no) selection column.
13. Press the up or down arrow key to select Y or N.
14. Press ENTER.
15. Repeat steps 12 through 15 until user profile is complete.
Panel Menus
Set Time & Date
System Information
Network Diagnostics
Network Programming
Panel Programming
Send/Receive Firmware Update
Table 6-1: User Profile Selectable Panel Functions
Type of Function Selectable Functions
To Next Page
Loading...
Need help?
General
