Honeywell IFP-2100ECS User Manual

Model IFP-2100/ECS Installation Manual LS10143-001SK-E
9-19
9.5.7 Point Programming for ECS-VCM, ECS-NVCM or ECS-RVM
To program module points:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Press 4 to enter point menu.
4. Press the up or down arrow key to select the desired module. Refer to Section 8.5 for available choices. Then
press ENTER.
Figure 9-8 Programming Points Screen for the ECS-VCM, ECS-NVCM or ECS-RVM Modules
5. Enter the point number. Press ENTER.
6. Press the up or down arrow key to select the type (switch or unused). Press ENTER.
7. Press the up or down arrow key to select the desired Function (See Table 9-7). Press ENTER.
8. Press ENTER to edit point name. See Appendix B or Press right arrow key to skip point name edit.
9. Repeat Steps 1 through 8 for all points.
Enter Point
Select SWITCH
Select a name
for the Point
or Unused

Honeywell IFP-2100ECS Specifications

General

Brand	Honeywell
Model	IFP-2100ECS
Category	Conference System
Language	English