Fire Alarm Control Panel IQ8Control C/M
90 FB 798951.GB0 / 01.09
Inhibiting MFAB activation
The master box or master box relay will not be activated if,
the cover contact (lock on outer hosing) is open. (factory setting of solder jumper on module: BR2 = open ;
BR3 = closed). The customer data of the Fire Alarm Control Panel must be programmed under menu point
Functional designation of the MFAB control module to suppress the activation of the master box when the
cover contact is open.
the operating panel keyboard has been enabled for operation (key-operated switch).
the master box is disconnected.
there is trouble with the master box.
Activation of the MFAB in dependency on the cover contact (BR2 and BR3)
The hardware adjustment of the activation of the master box is determined by the two solder bridges BR2 and
BR3 on the MFAB control module.
Factory setting Germany
D
configuration
BR2 = open The activation of the MFAB occurs in dependency on the customer data
programming. If, for BR3 = closed example, activation has been suppressed in the
menu point Functional designation of the MFAB control module when the cover
contact is open, the master box will not be activated in the case of an event when
the cover contact is open.
BR3 = closed
Configuration for the Netherlands
NL
The activation of the MFAB occurs
independently of the customer data
programming. If, for example, activation has been suppressed in the menu point
Functional designation of the MFAB control module when the cover contact is
open, the master box will still be activated in the case of an event by hardware
when the cover contact is open.
BR2 = closed
BR3 = open
To Next Page
Loading...
Need help?
General
