MultiBoot
Hardware and Software Guide B–3
Bootable Devices in Computer Setup
The tablet PC can start up from a USB device or the NIC only if
that device has been enabled for inclusion in MultiBoot.
To enable a device or location for inclusion in MultiBoot:
1. Open Computer Setup by turning on or restarting the
tablet
PC. Press f10 while the F10 = ROM Based Setup
message is displayed in the lower-left corner of the screen.
❏ To change the language, press f2.
❏ For navigation instructions, press f1.
2. To enable bootable media in USB drives or in drives inserted
into an optional docking device, use the arrow keys to select
Advanced > Device options. Then select Enable USB
legacy support.
– or –
To enable a NIC, select Security > Device security, and then
select Internal network adapter boot.
3. Save your preferences and exit Computer Setup by using the
arrow keys to select File > Save changes and exit, and then
follow the instructions on the screen.
Your preferences are set when you exit Computer Setup and they
take effect when the tablet PC restarts.
✎
To connect a NIC to a Preboot eXecution Environment (PXE)
or Remote Program Load (RPL) server during startup without
using MultiBoot, quickly press
f12 when the Network Service
Boot message appears in the lower-right corner of the screen.
To Next Page
Loading...
Need help?
General
