2
display debugging
Use display debugging to display the enabled debugging functions.
Syntax
display debugging [ module-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
module-name: Specifies a module by its name. To display the current module name, use the display
debugging ? command.
Examples
# Display all enabled debugging functions.
<Sysname> display debugging
DEV debugging switch is on
Related commands
debugging
ping
Use ping to determine whether the destination IP address is reachable, and display related statistics.
Syntax
ping [ ip ] [ -a source-ip | -c count | -f | -h ttl | -i interface-type interface-number | -m interval | -n | -p
pad | -q | -r | -s packet-size | -t timeout | -tos tos | -v | { -topology topo-name | -vpn-instance
vpn-instance-name } ] * host
Views
Any view
Predefined user roles
network-admin
Parameters
ip: Distinguishes between a destination host name and the ping command keywords if the name of the
destination host is i, ip, ipv, ipv6, l, ls, or lsp. For example, you must use the command in the form of ping
ip ip instead of ping ip if the destination host name is ip.
-a source-ip: Specifies an IP address of the device as the source IP address of ICMP echo requests. If this
option is not specified, the source IP address of ICMP echo requests is the primary IP address of the
outbound interface.
-c count: Specifies the number of ICMP echo requests that are sent to the destination. The value range is
1 to 4294967295, and the default is 5.
To Next Page
Loading...
Need help?
General
