446
• The terminal logging level 7 command enables log display for all levels (levels 0 through 7) on the
current terminal.
• The terminal debugging command only enables display of logs with the following severity levels:
{ Debug level (level 7).
{ Severity level higher than or equal to the level specified in the terminal logging level command.
Examples
# Enable the display of debug information on the current terminal.
<Sysname> terminal debugging
The current terminal is enabled to display debugging information.
Related commands
• terminal logging level
• terminal monitor
terminal logging level
Use terminal logging level to set the lowest level of logs that can be output to the current terminal.
Use undo terminal logging level to restore the default.
Syntax
terminal logging level severity
undo terminal logging level
Default
The lowest level of logs that can be output to the current terminal is 6 (Informational).
Views
User view
Predefined user roles
network-admin
Parameters
severity: Specifies a log severity level in the range of 0 to 7.
Usage guidelines
This command enables the device to output logs with a severity level higher than or equal to the specified
level to the current terminal. For example, if you set the severity argument to 6, logs with a severity value
from 0 to 6 will be output to the current terminal.
This command takes effect only for the current connection between the terminal and the device. If a new
connection is established, the default is restored.
Examples
# Configure the device to output logs with the debugging level and higher levels to the current terminal.
<Sysname> terminal logging level 7
To Next Page
Loading...
Need help?
General
