18
Parameters
ipv6-address: Specifies the destination IPv6 address for the operation. IPv6 link-local addresses are not
supported.
Examples
# Specify 1::1 as the destination IPv6 address for the ICMP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] destination ipv6 1::1
destination port
Use destination port to configure the destination port number for the operation.
Use undo destination port to remove the destination port number.
Syntax
destination port port-number
undo destination port
Default
The destination port number is 33434 for the UDP tracert operation.
No destination port number is configured for other types of operations.
Views
TCP/voice operation view
UDP echo operation view
UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
port-number: Specifies the destination port number for the operation, in the range of 1 to 65535.
Examples
# Set the destination port number to 9000 for the UDP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-echo
[Sysname-nqa-admin-test-udp-echo] destination port 9000
display nqa history
Use display nqa history to display the history records of NQA operations.
To Next Page
Loading...
Need help?
General
