7 PREPARING FOR USE
25
7.5 Preparing vehicle for rides on wet sand
– Make sure that no radiator covers ( p. 90) are installed.
V00814-01
– Check the radiator cap.
Value on the radiator cap 1.8 bar (26 psi)
» If the indicated value does not correspond to the setpoint
value:
Warning
Danger of scalding During motorcycle
operation, the coolant gets very hot and is
under pressure.
– Do not open the radiator, the radiator
hoses or other cooling system compo-
nents if the engine or the cooling system
are at operating temperature.
– Allow the cooling system and the engine
to cool down before you open the radiator,
the radiator hoses or other components of
the cooling system.
– In the event of scalding, rinse the area
affected immediately with lukewarm water.
– Change the radiator cap.
M01107-01
– Adjust the carburetor jetting and setting.
Info
The recommended carburetor tuning is available from
your authorized Husqvarna Motorcycles workshop.
– Clean the chain.
– Grease the chain.
Universal oil spray ( p. 123)
– Clean the radiator fins.
– Straighten bent radiator fins carefully.
Condition
Regular use in sand
– Change the piston every 10 operating hours.
7.6 Preparing vehicle for rides on wet and muddy circuits
– Make sure that no radiator covers ( p. 90) are installed.
To Next Page
Loading...
Need help?
General
