Husqvarna TC 85 User Manual

11 SERVICE WORK ON THE CHASSIS
58
Finishing work
– Install the air filter. ( p. 57)
– Install the air filter box cover. ( p. 56)
11.27 Removing the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
– Allow the exhaust system to cool down before performing any work on the vehicle.
Preparatory work
– Remove the right side cover. ( p. 59)
K00982-11
Main work
–
Remove screw
1
.
– Pull off the main silencer from the manifold at rubber
sleeve
2
.
11.28 Installing the main silencer
K00982-10
Main work
–
Mount the main silencer with rubber sleeve
1
.
–
Mount and tighten screw
2
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
Finishing work
– Install the right side cover. ( p. 60)
11.29 Changing the glass fiber yarn filling of the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
– Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
Preparatory work
– Remove the right side cover. ( p. 59)
– Remove the main silencer. ( p. 58)

Husqvarna TC 85 Specifications

General

Starter	Kickstarter
Transmission	6-speed
Engine Type	Single-cylinder, 2-stroke
Displacement	84.9 cc
Clutch	Wet multi-disc
Front Brake	Disc brake
Rear Brake	Disc brake
Front Tire	70/100
Rear Tire	90/100
Wheelbase	1290 mm
Final Drive	Chain