Husqvarna TC 85 User Manual

9 SERVICE SCHEDULE
34
after every race
Every 40 operating hours
Every 20 operating hours
Once after 10 operating hours
Service the shock absorber. ●
Check the screws and nuts for tightness. ○ ● ● ●
Check idle. ○ ● ●
Final check: Check the vehicle for operating safety and take a test ride. ○ ● ● ●
Make the service entry in the Husqvarna Motorcycles Dealer.net and in the Service and
Warranty Booklet.
○ ● ● ●
○ One-time interval
● Periodic interval
9.3 Recommended work
after every race
Annually
Every 40 operating hours
Once after 20 operating hours / Every 20 operating hours
Once after 10 operating hours / Every 10 operating hours
Change the front brake fluid. ●
Change the rear brake fluid. ●
Change the hydraulic clutch fluid. ( p. 70) ●
Grease the steering head bearing. ( p. 52) ●
Service the fork. ○
Service the shock absorber. ○
Check/adjust the carburetor components. ● ●
Perform minor engine service. (Check the inlet membrane. Check the clutch. Change
the piston under difficult operating conditions. Check the cylinder and Z dimension.)
● ● ● ●
Perform the intermediate engine service. (Change the piston. Check the cylinder and Z
dimension. Check the exhaust control for functioning and smooth operation.)
● ●
Perform major engine service including removing and installing engine. (Change the
connecting rod, conrod bearing, and crank pin. Check the transmission and shift
mechanism. Change all engine bearings.)
●
○ One-time interval
● Periodic interval

Husqvarna TC 85 Specifications

General

Starter	Kickstarter
Transmission	6-speed
Engine Type	Single-cylinder, 2-stroke
Displacement	84.9 cc
Clutch	Wet multi-disc
Front Brake	Disc brake
Rear Brake	Disc brake
Front Tire	70/100
Rear Tire	90/100
Wheelbase	1290 mm
Final Drive	Chain