7.0 Optional - Setup for Internet access 65
7.1 Connecting a boiler’s controller to an IP network 65
8.0 Updating boiler controller software 67
8.1 Updating software in a boiler that has no internet access 67
8.2 Updating software in a boiler that has internet access 68
9.0 Other operating procedures 69
9.1 Testing the fan operation 69
9.2 Testing the firing rate 70
9.2.1 Testing the high fire 70
9.2.2 Testing the low fire 70
9.3 Calibrating the fan 71
9.4 Performing a manual pump purge 71
9.5 Limiting the minimum and maximum firing rate of the boiler 71
9.6 Adjusting the space heating temperature 72
9.7 Adjusting the domestic hot water temperature 72
9.8 Checking the water flow in the boiler 72
9.10 Backing up and restoring a boiler's configuration and settings 74
9.10.1 Backing up a boiler's configuration and settings 74
9.10.2 Loading boiler configuration and settings from a device onto another boiler 74
9.11 Restricting access to areas in a controller 75
9.12 Switching a boiler to unoccupied "away" mode 75
9.13 Resetting configured settings to factory defaults 75
9.14 Changing and updating date and time 76
9.14.1 Setting up date and time to update automatically in a boiler connected to the
Internet 76
9.14.2 Changing the default date and time in a boiler not connected to the Internet 76
9.15 Changing default error lockout time periods 77
9.16 Changing default units of measurement displayed on the controller's screens 77
9.17 Setting the venting material 77
9.18 Programming a replacement touchscreen controller 78
To Next Page
Loading...
Need help?
General
