c. Zone Of > tap OK > select the control load that you wish to synchronize the current
load with> Save.
4.1.4 Removing an assigned control mode from a load
1.
To change a control mode, go to > choose the load you wish to change:
2. Choose a control mode (e.g., Reset Heating) > Tap Change... > Off > OK.
4.1.5 Changing settings in a load
After programming a controller, you can change the current settings of one or more loads.
Note
You can adjust the Outdoor design temperature in the Advanced Setup menu.
1.
To change one or more settings in a load, tap to display the Select a load screen.
2. Select a setting highlighted in blue > enter a new value/option > Save.
4.2 Setting loads using Advanced Setup
The Advanced Setup menu provides more options for the experienced installer. For a list of
operational settings in this menu, see Operational settings in the Advanced Setup menu:
temperature ranges and defaults on page 32.
1. Go to > Advanced Setup.
If the boiler has never been programmed, all loads will be set to "Off".
2. On the Select a load screen, choose a load (Load 1-4) > Choose a control mode (e.g.,
Reset Heating) > OK. To change the control mode, select the Change... button.
Once a control mode is assigned, all the load’s parameters can be edited individually.
Note
"Zone Of" is not available as an option until you have programmed a load with
one of the other control modes.
To Next Page
Loading...
Need help?
General
