4. Place the FIB (shown in Figure 124) in a safe location.
5. If needed, repeat steps 2 on page 126 through 3 on page 127 to remove the
other FIB.
Replace the fan interface board
6. To reinstall a fan interface board, or replace it with one from FRU stock, follow
the procedure in “Installing or replacing a fan interface board: 2145-92F” on
page 101.
Replacing an enclosure: 2145-92F
You can replace a faulty enclosure (FRU 01LJ112) of a 2145-92F expansion
enclosure with a new one from FRU stock.
Before you begin
DANGER
Multiple power cords. The product might be equipped with multiple power
cords. To remove all hazardous voltages, disconnect all power cords. (L003)
Figure 124. FIB parts removed from the chassis
128 SAN Volume Controller: Model 2145-SV1 Hardware Installation Guide
To Next Page
Loading...
Need help?
General
