SOURce Subsystem
Copyright © ITECH Electronic Co., Ltd. 70
Query syntax:
[SOURce:]CE:TA:RC? [MAXimum| MINimum]
Example
CE:TA:RC 10
[SOURce:]CE:TA:C <NRf+>[,NRf+][,NRf+]
This command is used to set or query the C value under Parallel RLC, Unit: uF
Syntax:
[SOURce:]CE:TA:C <NRf+>[,NRf+][,NRf+]
Arguments
<NRf+>,[NRf+],[NRf+]
Query syntax:
[SOURce:]CE:TA:C? [MAXimum| MINimum]
Example
CE:TA:C 10
[SOURce:]CE:TA:L:AINitial <NRf+>[,NRf+][,NRf+]
This command is used to set or query the initial current value of inductance, Unit:
A.
Syntax:
[SOURce:]CE:TA:L:AINitial <NRf+>[,NRf+][,NRf+]
Arguments
<NRf+>,[NRf+],[NRf+]
Query syntax:
[SOURce:]CE:TA:L:AINitial? [MAXimum| MINimum]
Example
CE:TA:L:AINitial 10
[SOURce:]CE:TB:R <NRf+>[,NRf+][,NRf+]
This command is used to set or query the R set under Rectifier single phase
RLC mode, Unit:Ω
Syntax:
[SOURce:]CE:TB:R <NRf+>[,NRf+][,NRf+]
To Next Page
Loading...
Need help?
General
