ITech IT8800 Series Programming Guide

Essential Commands
Copyright © ITECH Electronic Co., Ltd. 25
Chapter4 Essential Commands
STATus Subsystem
Those commands configure the status registers of the electronic load.
STATus:QUEStionable?
This query returns the value of event register. Event register is read only
register, it keeps all events sent to it. Read the quest event register will clear it.
Query Syntax
STATus:QUEStionable[:EVENt]?
Parameters
None
Examples
STAT:QUES:EVEN?
Returned Parameters
<NR1> (register value)
Related Commands
*CLS
STATus:QUEStionable:ENABle
The command set or read quest enable register. The register can make the
special bit of the quest event register set the query status bit register overview
bit (QUES) of the status byte register. The bit (bit 3) is the logic OR of all query
event register, is enabled by the quest status enable register.
Command Syntax
STATus:QUEStionable:ENABle <NR1>
Parameters
0 to 65535
Default value
0
Examples
STAT:QUES:ENAB 32 STAT:QUES:ENAB 1
Query Syntax
STATus:QUEStionable:ENABle?
Returned Parameters
<NR1> (register value)
Related Commands
STAT:QUES?
STATus:QUEStionable:PTRansition
The command set or read queries the value of the positive change enable
register, when the query register bit changes from 0 to 1, and the corresponding
bit of positive change enable register is 1, then the corresponding bit of the
quest event register is 1.
Command Syntax
STATus:QUEStionable:PTRansition <NR1>
Parameters
0 to 65535
Default value
0
Examples
STAT:QUES:PTRansition 32 STAT:QUES:
PTRansition 1
Query Syntax
STATus:QUEStionable:PTRansition?
Returned Parameters
<NR1> (register value)
Related Commands
STAT:QUES?

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English