ITech IT8800 Series Programming Guide

System Commands
Copyright © ITECH Electronic Co., Ltd. 29
Returned Parameters
<NR1>, <SRD>
Examples
SYST:ERR?
SYSTem:CLEar
This action is used to clear the error sequence information.
Command Syntax
SYSTem:CLEar
Parameters
None
Examples
SYST:CLE
Related Commands
SYST:ERR?
SYSTem:LOCal
The command sets the load to local mode when in RS232 mode. Can
use the buttons on front panel to operate.
Command Syntax
SYSTem:LOCal
Parameters
None
Examples
SYST:LOC
Related Commands
SYST:REM SYST:RWL
SYSTem:REMote
The command sets the load to remote mode when in RS232 mode. All
the buttons except for the LOCAL button will lose function. In the remote
state, press LOCAL key return to local mode.
Command Syntax
SYSTem:REMote
Parameters
None
Examples
SYST:REM
Related Commands
SYST:LOC SYST:RWL
SYSTem:RWLock
This command can set the load to remote mode, all the button on front panel
will lose function including LOCAL button. Use SYSTem:LOCal return to
local mode.
Command Syntax
SYSTem:RWLock
Parameters
None
Examples
SYST:RWL
Related Commands
SYST:REM SYST:LOC
SYSTem:KEY
This command is used to simulate the key pressing.
Command Syntax
SYSTem:KEY <NR1>
Parameters
0 to 255

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English